Our Products

DBX1424 Metal Dryer vent Box with Optional Trim Ring

Description:

The DBX1424 Dryer Vent Box with snap on trim ring is powder coated white, designed to work with pedestal and stackable dryers. The 14″ wide by 24″ tall, 24 gauge metal box and ring is designed to fit into a 2×6 framed wall. The DBX1424 has inside dimensions that are 3 1/2 inches taller than any other manufactured dryer vent enclosures. Thereby, accommodating all pedestal heights. This dryer vent box enclosure is designed to be used with or without the trim ring. It is designed to be installed in single family or multi-family units. This is not designed to be installed on a 1 hour firewall.

Part Numbers:

DBX1424MBT (includes Dryer vent box and trim ring)
DBXMB1424 (Dryer Vent Box only)
DBX1424MT (Metal Trim Ring only)

Packaging:

The DBX1424’s boxes are packaged 5 per carton. The DBX1424 Metal rings are packaged in a separate carton, 5 per carton

Dimensions:

The DBX1424 Box is 14 Inches wide by 24 Inches tall, 5 Inches Deep
Material: 24 Gauge Metal, powder coated white.

Benefits:

The DBX1424 is designed to recoup lost space in your laundry room. It helps eliminate the kinked hose behind your dryer which could be a potential fire hazard.

The DBX1424 is the only box on the market that is designed to meet all floor mount, pedestal and floor mount height requirements. It is designed to be used with or without a trim ring. The DBX1424 also has the Length identification label inside it to meet the 2015 IMC building code requirement. IMC 504.8.5

Architects & Engineering:

Building Code:

APPROVED FOR SINGLE AND MULTI-FAMILY CONSTRUCTION
INTERNATIONAL MECHANICAL CODE
SECTION 504
CLOTHES DRYER EXHAUST

SECTION 504.2 EXHAUST PENETRATIONS
Where a clothes dryer exhaust duct penetrates a wall or ceiling membrane, the annular space shall be sealed with noncombustible material, approved fire caulking or a noncombustible dryer exhaust duct wall receptacle.

SECTION 1502.4.6
“LENGTH IDENTIFICATION”
This section requires the installer to provide a tag or label within 6′ of the dryer exhaust stating how many elbows and length of the dryer exhaust until it exits the residence.

CONSTRUCTION SOLUTIONS PROVIDES THE LABEL INSIDE THE DRYER VENT BOX AT NO COST TO MEET THE BUILDING CODE REQUIREMENT.